What is facing work – Rules for facing surfaces and structures

  1. About facing work as a type of finishing work
  2. What is facing first: walls or floor?
  3. What is quality cladding?

In this article I will tell you about what facing work is, what place they occupy among the types of construction and finishing work. Let’s find out what cladding is and what materials it is made with. About facing work as a type of finishing work Facing work is a type of construction and finishing work.

Cladding is giving surfaces and structures an expressive aesthetic appearance by installing cladding materials. Installation is carried out using glue, mortar, mixture or frame. Also, facing works perform the function of protecting surfaces and structures from environmental influences. Facing materials are available in the form of sheets, slabs and tiles. The following types of facing materials are known: ceramic slabs and tiles, porcelain stoneware, decorative stone, asbestos-cement facing sheets, laminated paper, stemalite, drywall, and so on. These materials are distinguished by their operational and decorative qualities.

The most popular cladding material is traditional ceramic tiles. There is a huge selection of facing materials on the market of building and finishing materials. All of them are at the disposal of modern craftsmen and customers and will satisfy the most refined taste. Having the knowledge and experience in DIY repair, obtained on our website, you can decorate your home the way you like, according to your taste. The main thing is that you have enough imagination.

There are both external and internal facing works

They are carried out after general construction work, in parallel with painting work. If you have a house, not an apartment, then the facing work should be started from the upper floors. This is necessary so as not to trample or wipe off the facing materials on the lower floor while facing the upper floors. Which is tiled first: walls or floor? Very often the question arises – what to cover first: walls or floor? From the experience of many specialists in facing work, it follows that it is necessary to start facing work from vertical surfaces (walls, structures), and end with the floor. This must be taken into account in order not to damage or trample on freshly laid tiles on the floor when facing vertical surfaces. This rule applies to all rooms, except for plumbing (bath, toilet) and technical (garage, sink and others). It’s all about the water here. In these rooms, water can run off the walls. Therefore, so that it does not leak over time through the tile joints, you must first lay the floor, and then put the tiles on it, laid on vertical surfaces.

Water, flowing down, will fall on the floor tiles, and not at the joint between the wall and the floor. This will protect against the appearance of excessive moisture and, in this regard, from mold (Methods of dealing with mold, preventing its appearance). When you lay the first tile on the floor, let it dry for 3-4 days, and then cover it with sheets of cardboard to protect it from damage. What is quality cladding? So, remember the basic rules of high-quality cladding of surfaces and structures: Cladding must be rigid.
Facing materials must be firmly and securely glued or attached to the base, as they say, do not tear off the teeth.

The cladding must be flat in all directions and flat.
The surface should look like one flat, smooth plane. The cladding should not have cracks, dents, chips and efflorescence and mortar residues. The cladding should be made with the same width and mutually perpendicular joints, completely filled with mortar. Pay attention that the mortar does not protrude from the seams. The space between the base and the cladding must be completely filled with mortar. Emptiness should not be tapped. Facing work is a decorative finish.
This type of finishing work must be approached creatively. Some experiments will not hurt if they reflect your inner world, your impulses of the soul. But do not overuse and adhere to the rules of quality cladding.